Antaira Technologies - Media Converter
FCU-6001-SFP+ User Manual V 1.0
5. Trouble Shooting
This chapter contains information to help you solve issues. If the media converter is not functioning properly,
make sure the media converter is set up according to instructions in this manual.
The per port LED is not lit
Solution:
Check the cable connection of the media converter.
Performance is bad
Solution:
Check the speed duplex mode of the partner device. The media converter usually runs in auto-negotiation
mode. If the partner is set to half duplex, the performance will be poor.
Per port LED is lit, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full duplex. Some devices use a physical or software
switch to change duplex modes. Auto-negotiation may not recognize this type of full-duplex setting.
Why the Media Converter doesn’t connect to the network
Solution:
Check per port LED on the media converter. Make sure the cable is installed properly. Make sure the cable is
the right type. Turn off the power. After a while, turn the power on again.
