Antaira Technologies - Media Converter
FCU-6001-SFP+ User Manual V 1.0
4.2 Cabling
This section describes the functionalities of the media c
onverter’s components and guides you to
how to install it on the desktop. Basic knowledge of networking is assumed. Please read this
chapter completely before continuing.
Step 1:
Unpack the media converter.
Step 2:
Connect the 5V DC power adapter to the FCU-6001-SFP+ and verify that the Power LED lights up.
(Please refer to the
2.4 Power Information
section for power input.)
Step 3:
3-1:
Prepare a twisted-pair, straight-through
Category 5e/6/7 UTP cable
for Ethernet connection.
3-2:
Prepare a fiber cable for connection to the 10GBASE-T SFP+ slot, and make sure both sides of the
SFP transceiver are with the same media type.
(Please refer to the
3.5 Cable Connection
section for the type of connection.)
Step 4:
4-1:
Insert one side of
Category 5e/6/7 cable
into the media converter Ethernet port (RJ45) while the
other side of Category 5e/6/7 cable into the network devices' Ethernet port (RJ45), e.g., switch, PC or
server.
The UTP port (RJ45) LED on the media converter will light up when the cable is connected with the
network device. (Please refer to the
2.2 LED Indicators
section for the functions of LED lights.)
4-2:
Connect the
fiber cable
. Attach the duplex LC connector on the network cable to the SFP+
transceiver. Attach the fiber cable from the FCU-6001-SFP+ to the fiber network. TX, RX must be paired at
both ends.
Step 5:
When all the connections are all set and the LED lights all show normally, the installation is complete.
