7
Industrial Wireless Access Point
Hardware User's Manual
– AMS-2111
2.6 Cabling
◼
Twisted-pair segments can be connected with an Unshielded Twisted Pair (UTP) or Shielded
Twisted Pair (STP) cable. The cable between the equipment and the link partner (wireless AP,
switch, hub, workstation, etc.) must be less than 100 meters (328 ft.) long.
2.7 Wiring the Power Inputs
Please follow the steps below to insert the power wire.
1.
Insert the positive and negative wires into the V+, V- contacts on the terminal block connector
as shown below in
Figure 2.7
.
2.
Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure
2.8
.
Figure 2.8
Power Terminal Block
Figure 2.7
Power Terminal Block
