How to install the LED holder
3
2. If your suit still has the protective film on the outside of the
visor, remove the film, or at least pull it away from the top of
the visor.
a) Put a piece (10-15 cm) of masking tape on the outside of the
visor, along the upper edge. The amount of tape used here
is not important, though make sure it covers the middle part
of the visor.
b) Use the measuring tape to find the middle of the visor.
Measure along the upper edge of the visor from one side to
the other.
4
c) With the pen, mark the middle on the applied piece of tape.
5
3. Turn the suit to work on the inside. If your suit still has the
protective film on the inside of the visor, remove the film, or
at least pull it away from the top of the visor.
a) With the pen, make a small mark on the middle of the inner
visor tape. This mark should be aligned with the mark on the
outside masking tape.
4. Without removing the release papers, position the LED
holder inside the visor and align the top edge with the visor
according to
a) or b)
below.
a)
Suits with anti-fog lens
: Make sure the lens is placed cor-
rectly. Follow the top edge of the anti-fog lens when posi-
tioning the LED holder.
b)
Suits without anti-fog lens
: Follow the edge of the inner
visor tape (i.e. the edge you see through the visor from the
outside) to align the LED holder.
ATTENTION!
THE ADHESIVE STRIPS ON THE LED HOLDER ARE MADE
TO STICK PERMANENTLY AND CANNOT BE REMOVED
ONCE ATTACHED. TAKE CAUTION WHEN POSITIONING
THE LED HOLDER.
5. When carrying out the steps a-c below, make sure you
stand so you have a good overview over the attachment
area inside the visor.
6
a) Remove the release paper from the middle smaller pad on
the LED holder (see picture above) and position the holder
on the inside of the visor. Make sure the center mark on
the LED holder meets your marking on the visor tape (see
picture below).
7
b) Working from the middle to the left, remove the release
papers from the small pads one by one. Align with the visor
and attach.
c) Repeat b) and align/attach from the middle to the right.
6. Remove the release paper from the long, narrow pad.
a) Press firmly along the holder to attach.