Anrtisu Cell Master MT8212B, User Manual, Page: 64 / 294

FREQ/DIST Pressing the FREQ/DIST key in Transmission Measurement mode activates a
menu of frequency-related choices in the active function block. Use the corre-
sponding soft key to select the desired function, explained below. Use the key-
pad or Up/Down arrow key to change or enter values shown in the edit box.
Complete the entry by pressing the appropriate soft key frequency terminator.
q
Center
— Sets the center frequency. A specific center frequency can be en-
tered using the Up/Down arrow key, or the keypad and the
GHz
,
MHz
,
kHz
,
or
Hz
soft keys.
q
Span
— Pressing the
Span
soft key activates a menu of span related choices
in the active function block.
q
Edit
— Allows direct entry of a specific frequency span. Use the keypad or
Up/Down arrow key to select the span.
q
Full
— Sets the Anritsu Cell Master to its maximum frequency span, 2.975
GHz.
q
Min
— Sets the span to the minimum frequency.
q
Span Up 1-2-5
— Activates the span function so that the span may be in-
creased quickly in a 1-2-5 sequence.
q
Span Down 1-2-5
— Activates the span function so that the span may be
reduced quickly in a 1-2-5 sequence.
q
Back
— Returns to the previous menu level.
q
Start
— Activates the start frequency and sets the Anritsu Cell Master in the
Start/Stop mode. Use the keypad to enter the desired start frequency and
complete the entry by pressing the
GHz
,
MHz
,
kHz
, or
Hz
soft key to accept
the start frequency input.
q
Stop
— Activates the stop frequency and sets the Anritsu Cell Master in the
Start/Stop mode. Use the keypad to enter the desired stop frequency and com-
plete the entry by pressing the
GHz
,
MHz
,
kHz
, or
Hz
soft key to accept the
stop frequency input.
q
Signal Standard
¾ Opens a menu of soft keys used to select the signal stan-
dard to be used. For more information on signal standards, refer to Appendix
C.
q
Select Standard
¾ Opens the signal standard menu, showing the currently
selected signal standards. Use the soft keys to navigate the list. Press the
Show All
soft key to show the complete signal standard list. When the
complete list is displayed, the currently selected signal standards are
marked with an asterisk. Press the
Show Selected
soft key to show only
the currently selected signal standards.
q
Select Channel
¾ Sets the channel information for the available standard.
q
Uplink
¾ Selects only uplink frequencies.
q
Downlink
¾ Selects only downlink frequencies.
q
Back
¾ Returns to the previous menu.
2-40
Chapter 2 Functions and Operations