Anrtisu Cell Master MT8212B, User Manual, Page: 54 / 294

q
Back
— Returns to the previous menu level.
q
Signal Standard
¾ Opens a menu of soft keys used to select the signal stan-
dard to be used. For more information on signal standards, refer to Appendix
C.
q
Select Standard
¾ Opens the signal standard menu, showing the currently
selected signal standards. Use the soft keys to navigate the list. Press the
Show All
soft key to show the complete signal standard list. When the
complete list is displayed, the currently selected signal standards are
marked with an asterisk. Press the
Show Selected
soft key to show only
the currently selected signal standards.
q
Select Channel
¾ Sets the channel information for the available standard.
q
Uplink
¾ Selects only uplink frequencies.
q
Downlink
¾ Selects only downlink frequencies.
q
Back
¾ Returns to the previous menu.
AMPLITUDE Choosing AMPLITUDE in Power Meter mode causes the soft keys, below, to
be displayed and the corresponding values to be shown in the message area. The
following soft keys are available when the AMPLITUDE key is pressed.
q
Units
— Choose either Watts or dBm.
q
Rel
— Selects whether relative power is on or off. When on, the message
Relative: On
will show in the message area.
q
Offset
— Turns offset on or off. When on, a value from 0-60 dB can be en-
tered.
q
Zero
— Turns zero adjust on or off.
MEAS/DISP The following soft key is available when the MEAS/DISP key is pressed in
Power Meter mode.
q
RMS Averaging
— Activates the RMS Averaging menu. The RMS average is
calculated by taking the log of the average power and the power is calculated
from voltage. The number of points to average can be set to low, medium or
high.
q
Off
— Turns off RMS averaging.
q
Low
q
Medium
q
High
q
Back — Returns to the previous menu.
2-30
Chapter 2 Functions and Operations