Anritsu Network Master MT9090A Series, Operation Manual, Page: 72 / 200

3-4 MT9090A/MU909011A Network Master User’s Guide
Note
Note
If a screen similar to the ones shown in Figure 3-1,
Figure 3-2 or Figure 3-3 does not appear after powering
up, the unit may have failed. Run the unit through a
power cycle (power down / power up). If the problem
persists, contact the Anritsu Technical Support Center or
your local Arnitsu representative (see “Anritsu
Corporation Contact” on page xix).
To Power Down the unit:
1. Press the Menu/Power key , a pop-up menu
appears.
2. Use the Down Arrow key to highlight the Power
Down selection in the menu.
3. Press the Set key to accept the highlighted
menu selection. The following message appears:
“Are you sure you want to Power Down?”.
4. Highlight Yes and then press the Set key .
Note
Note
You can force a Power Down at any time by holding down
the
Menu/Power key for 10 seconds.
General Functions Pop-up Menu
With one of the initial test application screens displayed,
press the
Menu/Power key . The General Functions pop-up
menu appears (see Figure 3-4 on page 3-5).