Anritsu Network Master MT9090A Series, Operation Manual, Page: 111 / 200

MT9090A/MU909011A Network Master User’s Guide 4-13
Power Meter Step Screen
Note
Note
The Power Meter Step screen is only available on units
equipped with the optional (factory installed) Power
Meter.
The Power Meter Step screen appears when you enter the
Fault Locate test application, providing the unit in use has the
optional (factory installed) Power Meter and that
Enable
Power Meter Step is selected on the Preferences Setup screen
(see Figure 4-4 on page 4-5).
Depending on the Threshold value set for the Power Meter
step, one of the following ratings will be displayed: PASS,
FAIL, Over Range, or Under Range. The following five
figures show examples for each rating.
Figure 4-8: “PASS” Rating
Note
Note
The image above is an example from a 1550 nm unit.
When using a 780 nm unit
Continue ( F1 ) is active.