Anritsu MX183000A, Operation Manual, Page: 58 / 226

Chapter 4 Operation
4-4
4.2 Setup Procedure
The basic setup procedure is as shown below:
Start
Launch MX183000A
Set BER measurement method
End
Start measurement
Set measurement point
Set the MP1800A and
MT1810A IP address and port
number using MX180000A
control software
Set MU183020A bit rate using
MX180000A control software
Print /save measurement
results
Set module to be controlled
from MX183000A
Select PCIe Link Sequence,
USB Link Sequence, or Jitter
Tolerance Test for the
measurement application from
Application Selector
Select MP1800A or MT1810A
IP address and port number,
and check connection
Jitter Tolerance Test
Set jitter modulation frequency
Scope of this document
Set standard data
Setting measurement frequency
PCIe Link Sequence
USB Link Sequence
Set sequence to be executed
Set LTSSM Link for Tx
Execute sequence
Check link status using device
debugging function or ED BER
measurement function
Run Jitter Tolerance test?
*PCIe Link Sequence only
Yes
No
Figure 4.2-1 Setup procedure