Anritsu MX183000A, Operation Manual, Page: 18 / 226

Chapter 1 Outline
1-2
1.1 Outline
The MX183000A High-Speed Serial Data Test Software (hereinafter
referred to as “MX183000A”) controls the following devices and allows
jitter tolerance to be measured in compliance with the relevant standards
for the 10 Gbit/s and 20 Gbit/s bands, together with generation of
PCIe/USB link sequences.
● MP1800A Signal Quality Analyzer or
MT1810A 4-slot Chassis
● MU181000A 12.5 GHz Synthesizer or
MU181000B 12.5 GHz 4-port Synthesizer
● MU181500B Jitter Modulation Source
● MU183020A 28G/32G bit/s PPG or
MU183021A 28G/32G bit/s 4ch PPG
● MU183040A 28G/32G bit/s ED or
MU183041A 28G/32G bit/s 4ch ED
● MU183040B 28G/32G bit/s High Sensitivity ED or
MU183041B 28G/32G bit/s 4ch High Sensitivity ED
MX183000A controls MP1800A or MT1810A via Ethernet. Jitter
Tolerance Measurement mode measures the bit error rate or bit error
while varying the MU181500B jitter frequency and amplitude.
PCIe/USB Link Sequence mode generates data sequences for setting the
target device to loop-back state using 32G PPG.
Control PC
Jitter modulation
frequency,
Jitter modulation
amplitude,
Test pattern
Bit error rate
Figure 1.1-1 Setup and measurement items of MX183000A