Anritsu MX183000A, Operation Manual, Page: 108 / 226

Chapter 5 Remote Control
5-2
5.1 Setting Interface for Remote Control
This section describes the remote interface setting method for
MX183000A.
1. In the MX183000A main screen, click the Setup menu, and then
click Remote.
Figure 5.1-1 Remote Setting Screen
2. Select either Ethernet or GPIB.
3. When Ethernet of Remote Interface is selected
TCP Port can be set. Set a number that does not duplicate the TCP
Port setting for the MP1800A or control PC on which the software is
installed.
TCP Port setting initial value:
5000
TCP Port setting range: 1024 to 5001
The IP address cannot be changed on the Remote Setting screen.
Change the IP address on the Setup Utility of the MP1800A or on
the network setting of the PC controller.
4. If GPIB is selected
Set the GPIB address within 1 to 30. The initial value is 3.