Anritsu Mainframe MU909060A Series, Operation Manual, Page: 34 / 190

Chapter 1 Overview
1-10
1.3.2 Installing Ni-MH Battery Pack
Install the Ni-MH battery pack as described below.
1. Power down the unit.
2. Open the battery compartment (Figure 1.3-1) by pulling the latch
while lifting the battery compartment cover.
3. Remove any installed batteries.
4. Plug the connector on the Ni-MH battery pack into the socket next
to the module release latch (white plastic latch in battery
compartment).
5. Slide the Ni-MH battery pack into the battery compartment making
sure that the battery release pull (red ribbon) is tucked underneath
the pack, but leaving enough of the release pull exposed to remove
the battery pack later when necessary. Also ensure the THIS SIDE
UP label is visible.
6. Close the battery compartment cover.
Figure 1.3.2-1 Open Battery Compartment
Ni-MH battery pack plug
Module release latch
Ni-MH battery pack
Battery release pull (red ribbon)