MA2700A UG
PN: 10580-00361 Rev. D
2-3
Chapter 2 — MA2700A Overview
2-3 Connections
2-3
Connections
Connect the MA2700A to an instrument for locating interference
signals as follows:
1.
Connect a directional antenna to the male N-connector (inside the
coupling nut).
2.
Connect the USB cable between the MA2700A and the Anritsu
instrument.
3.
Connect the coaxial cable between the MA2700A and the Anritsu
instrument’s RF Input connector.
Once detected, the MA2700A can be used to capture bearing and/or GPS
data while in other interference mode measurements and even other
supported instrument measurement modes, including spectrum
analyzer mode.
Figure 2-2.
MA2700A with Attached Yagi Antenna