Anritsu BERTWave MP2100B, Operation Manual, Page: 74 / 382

Chapter 2 Before Use
2-20
2.9 Turning Power On/Off
2.9.1 Power-on
1. Connect the power cord plug, referring to Section 2.3 “Power
Connection”.
The BERTWave enters the standby state and the power switch lamp
lights orange.
2. Press the power switch.
The power lamp lights green and the Windows start-up begins.
3. In 30 seconds, the selector screen is displayed.
Figure 2.9.1-1 Selector Screen
Notes:
If no button on the selector screen is touched within 15 s, the
[Main Application] is executed by default.
Do not press the power switch while the start-up screen is
displayed, otherwise the BERTWave Control software may not
start normally.