Anritsu BERTWave MP2100B, Operation Manual, Page: 71 / 382

2.8 Installing Optical Transceiver
2-17
2
Before Use
2.8 Installing Optical Transceiver
An optical transceiver can be used by adding the Option 051.
For recommended optical transceiver model names, refer to Section 8.2.2
“Optical Transceiver Types”.
The optical transceiver can be installed or removed (hot-swap) while the
BERTWave power is on.
2.8.1 Installing Optical Transceiver
1. Check that the optical transceiver specifications for wavelength and
bit rate match the test conditions.
2. Hold both sides of the optical transceiver between thumb and
forefinger.
3. Insert the optical transceiver into the slot on the front panel until it
clicks.
4. Remove the protective cover from the optical transceiver.
5. Lift the lever to lock the optical transceiver.
Figure 2.8.1-1 Installing Optical Transceiver
CAUTION

When inserting the optical transceiver, set the optical
transceiver lever to the up position. If the optical
transceiver is inserted with the lever down, sometimes
the transceiver may not be fully inserted.