Anritsu BERTWave MP2100B, Operation Manual, Page: 66 / 382

Chapter 2 Before Use
2-12
2.4 Connecting Peripheral Devices
USB devices
USB devices such as mouse, keyboard, storage, etc., can be connected to
the left side panel USB connector.
No panel operations are required before removing USB devices from the
BERTWave. USB devices can be removed at any time as long as no files
are being written to or read from the USB device.
External Monitor
Connect an external monitor to the connector of the left-side panel
monitor.
The supported monitor resolutions are 1280×800 dot or more. Available
interfaces are RGB and DVI-D signal link.
Ethernet
Connect to the Ethernet connectors on the left side panel.
Either one of two connectors can be used, but each connector must have a
different IP address.
To set the connector IP address, refer to Section 2.14 “Setting Interface
for Remote Control”. However, when cables are connected to both
connectors, remote control can be performed from one connector.
When using the Ethernet cable, select a category-5 or better crossover
cable.