Anritsu BERTWave MP2100B, Operation Manual, Page: 318 / 382

Chapter 10 Maintenance
10-14
10.8 Storage
Wipe off dust, fingerprint marks, stains, spots, etc. from the surface of the
BERTWave before storing it.
Fit the attached coaxial connector cover to the coaxial connector on the
front panel. Also, put the cap on the optical connector.
Put the power cord, CD-ROM and other accessories in the accessory box
and store it with the main frame.
Avoid storing the BERTWave in these places:
 In direct sunlight for extended periods
 Outdoors
 In excessively dusty locations
 In liquids, such as water, oil, organic solvents, and medical fluids, or
places where these liquids may adhere
 In salty air or where chemically active gases (sulfur dioxide, hydrogen
sulfide, chlorine, ammonia, nitrogen oxide, or hydrogen chloride etc.)
are present
 Where toppling over may occur
 In the presence of lubricating oil mists
 In places at an altitude of more than 2,000 m
 In the presence of frequent vibration and mechanical shock, such as in
cars, ships, and airplanes
 Places with temperatures and relative humidity in the following
ranges:
Temperature:
lower than –20°C or higher than 60°C
Humidity: 90% or more
Recommended storage conditions
It is recommended that the BERTWave be stored in a place that meets the
ambient conditions suggested above, plus the following conditions, if it is
not to be used for a long period of time:
 Temperature: 5 to 45°C
 Humidity: 40 to 80%
 Little temperature and humidity fluctuations within one day