Anritsu BERTWave MP2100B, Operation Manual, Page: 222 / 382

Chapter 7 Measuring Waveform
7-36
7.9 Collecting Data
Once the data collection is started, the waveform is displayed on the
screen.
Starting data collection
1. The waveform of the channel with the monitor signal input is
displayed.
When monitoring the signal input to the Ch A In connector, touch the
Channel A trace display button to set the button display to [CH A
On].
When monitoring the signal input to the Ch B In connector, touch the
Channel B trace display button to set the button display to [CH B
On].
2. Touch the sampling start/stop button to display [Sampling at the
button display.
The elapsed time, number of samples and number of waveforms are
displayed in the title bar when [Accumulation Type] is set to
[Limited].
When [Averaging] is set to 2 or more in the Pulse mode, the number
of waveforms is displayed in the title bar.
The data collection can also be started by the [All Measurements Start]
button shown in Figure 4.1-1.
Stopping data collection
Touch the sampling start/stop button, and then set to [Sampling Hold].
When, in the Setup dialog box, Accumulation Type is set to [Limited], the
data collection process stops when the at-end conditions are met.
The data collection can be started by touching all measurement stop
button as shown in Figure 4.1-1.