Anritsu 3GPP, Measurement Manual

Page: 217 / 244

LTE and TD-LTE Coverage Mapping 7-5 Coverage Mapping Menu
3GPP MG PN: 10580-00234 Rev. Y 7-13
Mapping Save/Recall Menu
Key Sequence:
Measurements > Over-the-Air > Mapping > Save/Recall Points/Map
Save KML Points: Press this button to save the KML points.
FileName.kml will be stored in the default save location. From the File
menu, press Save, then Change Save Location to change default
location. Refer to
“Save the Coverage Mapping Information” on page 7-7 .
Save Tab Delimited Points: Press this button to save the points in a tab
delimited text file. FileName.mtd will be stored in the default location.
Save JPG: Press the Save JPG key to save a .jpg file of the current
screen.
Recall a Map: Opens the Recall submenu (shown at the bottom left of
this page) for selecting a map to display on the screen. The default map
type is .azm. Press the File Type submenu key to select a different map
type to recall.
Recall KML Points Only: Opens the Recall submenu for selecting a .kml
file. Displays the saved locations overlaid on the current map or the
default grid.
Recall KML Points With Map: Opens the Recall submenu for selecting
a .kml file. The map that was used when the points were saved will be
recalled if it is available.
Recall Default Grid: If you do not have a GPS embedded map but are
out in the field making measurements, the Recall Default Grid submenu
allows you to save points and the corresponding GPS coordinates (or
screen coordinates for indoor maps) to view at a later time. You can also
load the map after acquiring points, or switch maps at any time without
losing data.
Back: Returns to the “Coverage Mapping Menu” on page 7-12 .
Figure 7-9. Mapping Save/Recall Menu
Back
Mapping Save/Recall
Save
KML
Points
Save
Tab Delimited
Points
Save
JPG
Recall a Map
Recall KML
Points
Only
Recall KML
Points
With Map
Recall
Default
Grid
Recall
Sort By
Name Type Date
Sort Order
Ascend Descend
File Type
AZM
Refresh
Directories