Anritsu 37 C Series, Operation Manual, Page: 374 / 603

37XXXC OM A-39
ALPHABETICAL LISTING C
MENU DESCRIPTION GPIB COMMAND
CONFIRM
CALIBRATION
PARAMETERS None
OFFSET LENGTH
OF TRM REFLECTION
XXXX
Enter the offset length of the TRM reflection. TOL; TOL?; ROL;
ROL?
TYPE OF
TRM REFLECTION None
OPEN
(GREATER THN Zo)
Specifies the reflection to have an impedance value greater
than the reference impedance (Z
0
)
.
This is typically an open
device.
RGZ; RXZ?
SHORT
(LESS THAN Zo)
Selects the reflection to have an impedance value less than
the reference impedance (Z
0
). This is typically a short de-
vice.
RLZ; RXZ?
MICROSTRIP
PARAMETERS
XXXXXXX
Calls Menu C16 or 16A, which lets you change microstrip
parameters. None
TEST SIGNALS Calls menu CAL_SU2, which lets you enter calibrate Flat
Test Port Power or change source power(s) and attenuator
settings. None
START CAL Starts the standard calibration sequence using microstrip
standards. BEG
PRESS <ENTER>
TO SELECT
OR CHANGE
Pressing the Enter key implements your menu selection. None
Menu C3J, ConfirmCalibration Parameter 3