Anritsu 3656B W1, User Manual, Page: 58 / 278

3-5 Running the Verification Software Using the 2300-584-R Software with the ME7838E
3-6 PN: 10410-00286 Rev. L 3656B W1 Cal/Ver Kit & 2300-584-R PVS UG
3-5 Running the Verification Software
After the VNA and PC have been configured as described above, you are ready to run the program and perform
the calibration/verification. Make sure you have the following information available:
• Serial number of the 3656B W1 Calibration/Verification Kit
• Serial number of the 3739A/B/C Broadband/Millimeter Wave Test Set
• Model number and serial number of the Port 1 BB/mm Module
• Model number and serial number of the Port 2 BB/mm Module
Procedure
1. With the equipment and software configured as described in “Configuring the Hardware” on page 3-1 ,
turn on the computer and allow it to start Windows.
2. Locate the
Anritsu W1 Verification
icon (shown below) on the desktop and double-click it.
3. The program displays an
About
dialog box with version information. Click
OK
to continue.
4. The
Test Operator Name
dialog box appears. Enter a user name or other identification.
Figure 3-6. About Dialog
Figure 3-7. Name Dialog