anovafurnishings.com
888.535.5005 tel
Assembly InstructIons
rcPwf6 6 ft Flat Bench
tools needed:
• 9/16” Open-end or Box-end Wrench
• Ratchet with 9/16” Socket
• 18v (or more) Driver with No. 3 Phillips Head Bit
2 x
3/8” X 1.25”
Hex Head Bolt
8 x
3/8”
Lock Washer
2 x
3/8” X 3.00”
Carriage Bolt
Assembly:
The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
Assembly HArdwAre:
bencH comPonents:
2 x
Bench Support
5 x
Seat Plank
Seat End Cap
Seat Plank
2.25” long
Carriage Bolts
packaging cardboard
or other soft surface
Flat Washer
Nylock Nut
2 x
Seat Brace
8 x
3/8” X 2.25”
Carriage Bolt
14 x
3/8”
Flat Washer
3. Place the five Seat Planks across the two Seat End Caps allowing the
Carriage Bolts to pass through the predrilled mounting holes.
NOTE: When laying out the Planks, make sure the face of the Planks with
the predrilled pilot holes faces upward.
Seat End Cap
1 x
Seat Support
2 x
Seat End Cap
10 x
3/8-16
Nut
10 x
Phillips Head Screw
Lock Washer
packaging cardboard
or other soft surface
Flat Washer
Nylock Nut
Lock Washer
2.25” long
Carriage Bolt
Seat Plank
Bench Support
Seat End Cap
2 x
3/8-16
Nylock Nut
3.0” long
Carriage Bolt
3” Long
Carriage Bolt
4. Place a Bench Support over each end of the Planks allowing the carriage bolts to pass through the mounting holes.
Install a Flat Washer, Lock Washer, and Nut on each of the 2.25” Bolts. Tighten the hardware finger tight so adjustments can be
made later.
2. Locate the two Seat End Caps and place them about 6 ft apart on the
packaging cardboard or other soft surface to avoid scratching the product.
Insert a 3” Carriage Bolt through the center hole in each End Cap.
Insert 2.25” Carriage Bolts through the other 4 holes in each of the End
Caps.
Bench
Support
