1 — In Ground Support
2, 3, or 4 — Seats
(Straight or Curved)
Assembly InstructIons
D1005
46” Round Table
D1080
46” Square Table
D1081
46” Square Table
D1135
46” Square Table
D1192
46” Round Table
D1193
46” Round Table
F1005
46” Round Table
F1019
46” Round Table
F1072
46” Octagon Table
F1074
46” Octagon Table
F1078
46” Square Table
F1080
46” Square Table
F1081
46” Square Table
F1135
46” Square Table
F1191
46” Octagon Table
tools neeDeD:
Ratchet with 1/2” Socket
•
Ratchet with 3/4” Socket
•
1/2” Open-end or Box-end Wrench
•
3/4” Open-end or Box-end Wrench
•
Level
•
40 — 5/16”
Washer
20 — 5/16” X 1.25”
Hex Head Bolt
Assembly:
The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
A
SI 145_O HRD88 S11
7
2. Locate the Inground Support and the Table
top Adapter and lay them out on the packing
cardboard or other soft surfaced workspace.
3. Align the mounting holes in the Table top
Adapter with the holes in the appropriate end
of the Inground Support. Install one of the
1.375” O.D. Washers onto one of the 1/2” x
1.5” Long Bolts and insert the Bolt through both
parts, with the Bolt head on the outside surface of
the Inground Support. Install a 1.375” O.D. Washer
and 1/2” Nylon Insert Nut on the inside end of the
Bolt.
Use the Ratchet with 3/4” Socket and 3/4” Wrench
to tighten the Nuts.
Repeat this for the other two mounting holes on
the top side of the Adapter/Support assembly.
Turn the assembly over and repeat for the three
mounting holes on the other side of the assembly.
4. Determine the location for Table.
IMPORTANT: Locate underground utilities and avoid
them while digging the hole for the concrete base.
Model D1005 shown.
Tabletop shape and pattern may vary.
Seat shape and pattern may vary.
Assembly HArDwAre:
bencH components:
F1192
46” Round Table
F1193
46” Round Table
F2121
46” Octagon Table
r1111I
46” Square Table
r1113I
46” Round Table
6 — 1/2-13 x 1.5”
Hex Head Bolt
14 — 1/2-13”
Nylon Insert Nut
28 — 1.375” O.D.
Washer
8 — 1/2 x 5.5”
Hex Head Bolt
1 — Tabletop
Round, Square, or Octagon
2, 3, or 4 — Seat Supports
1 — Tabletop Adapter
20 — 5/16”
Flanged Hex Nut
.562” ID Washer
Nylon Insert Nut
1.5” Long Bolt
.562” ID Washer
Tabletop Adapter
Inground Support
Tabletop Adapter
Inground Support
Packaging cardboard or
other soft work surface
anovafurnishings.com
888.535.5005 tel