1
User instructions
ArcSource 140 COB Recessed US
The lighting unit generates light by means of high power LED multichip. The product was designed for
installation to a lower ceiling and is intended for indoor use only.
1. Attention
Do not install the lighting unit near high inflammable liquids or materials.
Do not allow anything to rest on the lighting unit.
Do not use the lighting unit near high humidity or water or expose to the rain.
Do not install the lighting unit near the naked flames.
Do not install the lighting unit in dirty,dusty or badly ventilated location.
Sufficient air accessing to the housing of the unit has to be ensured,
there must not be any heat or anti-noise insulation around 0.6m x 0.6m
around the unit (non-IC rated fixture).
CAUTION!
Avoid looking directly into the LED light beam at close range!
2. Installation
1. Prepare a circular opening in the lower ceiling (1) as shown at the picture below.
2. Insert the ArcSource 140 COB Recessed into the opening. Both adjustable rests (3) must be turned at
bracket (4) position to pass them throw the aperture.
