Page 22 of 24
10 Storage
When finished using the vacuum cleaner, empty the dust canister and clean
the filters.
You can either recharge the battery first, or store it away in a dry cool place.
Switch of and unplug the battery charger when not in use, or when fully
charged.
10.1 Wall Mount
There is a Charging Dock / Storage Bracket supplied
with screws and wall plugs should you prefer to hang the
vacuum cleaner on the wall.
To install the Charging Dock / Storage Bracket position the Charging Dock
/ Storage Bracket on the wall, near a power point and at a suitable height
where the vacuum cleaner will not touch the floor.
Mark the screw holes through onto the wall.
Using a suitable drill (wood drill bit for timber wall, or masonry drill bit for
brick / concrete walls, drill holes Ø6mm and 35 - 40mm deep.
Insert the plastic wall plugs into each hole and gently hammer in until they
are flush with the wall, place the Charging Dock / Storage Bracket over the
holes then insert the screws and tighten up. Do Not Overtighten.
Hang the vacuum cleaner as shown:
Front View Side View
