Page 6 of 12
A Peltier cooler, is a solid-state active heat pump which transfers heat from one side of the device
to the other side against the temperature gradient (from cold to hot), when power is supplied.
Such an instrument is also called a Peltier Device, Peltier Diode, Peltier Heat Pump, Solid State
Refrigerator, or Thermoelectric Cooler (TEC).
THE ADVANTAGES OF TEC
•
Thermoelectric coolers have no compressor.
•
No Freon or other liquid or gaseous refrigerants required.
•
Quiet operation.
•
No Vibration.
•
Very low power consumption.
•
Compact size and light weight make TEC well suited for miniature coolers.
•
High reliability – Can work for many hours with no failures when installed and used as per the
recommendations stated in this instruction manual.
•
Relatively low cost and high effectiveness.
4 Installation
IMPORTANT
: Ventilation is very important for this kind thermoelectric wine cooler. The electronics
controlling the cooler will damage easily if the ventilation is bad. It will also reduce the life of the wine
cooler.
When positioning the wine cooler, ensure that there is at least a 5cm clearance at the sides and top,
and at least a 10cm clearance at the back of the wine cooler as these areas are the main outlet for
heat. This will allow for adequate ventilation.
This appliance is designed to be free standing only, and should not be recessed or built-in.
4.1 Levelling the Appliance
Before using the wine cooler, it is important that the appliance is level.
The appliance door must be parallel with the side of the cooler, but also, the appliance must tilt
backward a couple of degrees to help the door close.
To level the door with the side of the cabinet, first close the door.
Ensure the appliance is standing in its final position.
Check to see if the door is parallel with the side of the appliance. If not, adjust the front feet one at
a time by screwing in or out until the door is level with the side. (note: the rear feet are not adjustable).
Note
: The door of this appliance does not close automatically; therefore, it is important that you
ensure the door is closed properly after each use.