000-015-480 Issue 5
22
nd
May 2017
Anite S-CORE Getting Started Guide
Page 31 of 47
Commercial In Confidence
Setting
Description
Loss)
When using conducted testing, a typical value for the external attenuation is
7dB, and this value depends on the cable length/quality and how many RF
combiners/splitters and used.
When using antenna couplers, the external attenuation depends on the
equipment and the UE’s antenna characteristics. We recommend using 15dB
as a good starting point.
It is generally better to specify an external attenuation that is slightly too low
rather than too high. Specifying a value that is too high can lead to a Layer 1
system error, which requires the S-CORE unit to be re-booted.
EPS Attach Type
Based on the UE capability and test requirements, select the EPS attach type
in this option:
EPS Only
Combined Attach
UE Category
Select the supported UE category to
1
or
4
.
PDN1 tab
Important settings needed for testing:
Table 9
PDN1 settings
Setting
Description
MS IP Address
IPv6 for mobile.
For more information, see the
Anite S-CORE Application Testing:
System Configuration Guide
.
AP Name
Please set the Access point name for the first PDN request from the
device. In the above example the first PDN request is for the PDN
VZWIMS
