000-015-480 Issue 5
22
nd
May 2017
Anite S-CORE Getting Started Guide
Page 11 of 47
Commercial In Confidence
2.3
Anite WLAN Test Accelerator
The delivery of the S-CORE test system may contain an Anite WLAN Test Accelerator, which is pre-
configured with the correct settings and is ready to use.
Front and Rear view
The relevant buttons/ports on the Anite WLAN Test Accelerator are shown above and described in
the following table.
Table 4
Anite WLAN Test Accelerator panels
Button/Port
Description
Power button
To power the unit into and out of standby mode. The button lights up
when power is supplied to the unit. The colours denote the following
modes:
Orange light: The unit is in standby mode.
Green light: The unit is in normal operating mode.
RF antenna ports
Convey antenna 1-4 (ANT 1
–
ANT 4) RF signal to and from the device
under test.
Ethernet ports
RJ-45 connection for connectivity to the S-CORE Connect unit and the
Test System PC.
Power inlet switch
Switches the power to the unit. Switching this off isolates the unit from
the mains supply.
