Anita GARUDAN GPS/G-4032, User'S Manual And Spare Parts Book

Page: 25 / 101

ANITA ©
MP01700EN_161116 25
13. SETTING OF BOBBIN WINDER
Setting amount of wound thread (fig . 43)
A. Loosen screw ( 2) on the stopper lever ( 3) .
B. Movement of stopper lever ( 3) in the
direction of arrow (A) increases capacity
of bobbin thread and vice versa.
C. Tighten the screw ( 2) .
Machine can be equipped with the device BC
(bobbin counter - measuring of lower thread)
This function os controlled by parameter 43
(on/off)
Fig . 43
Setting of driving mechanism of the bobbin winder :
A. Remove 3 screws ( 5) - fig. 43, and take out the
bobbin winder ( 4), reaching access to the driving
wheel (6 ), fig . 44 .
B. Loosen screws ( 7) and set the wheel (6 ) by moving
it on the main shaft (8) until it is in the required
contact with the driving ring of the winder (4).
Fig . 44
14. SENSORS FOR INITIAL POSITION OF X, Y AND Z AXIS
Setting for initial position of X and Y axis and position of Z axis (needle) is set in the
production plant, fig. 45
Fig. 45
www.garudan.cz