Anita Garudan GC-3317 Series, User'S Manual And Spare Parts Book

Page: 16 / 61

ANITA ©
GC-3317-443 MH
16
19. HEIGHT OF THE FEED DOG
Standard height of the feed dog is 1,4 mm from the surface of throat plate (2). When the
feed dog height needs to be adjusted according the sewing conditions or after the feed dog
is replaced, follow the procedure described below. Loosen screws (3) in the feed dog. Adjust
the position to the needle bar. Securely tighnten the screws (3) in the feed dog.
(fig.14)
20. FORWARD REVERSE SEAM RATIO
Loosen four screws (1). When increasing the forvard stitching length, turn the eccentric pin
(2) clockwise (toward A) using a screwdriver. When decreasing the forvard stitching length,
turn eccentric pin (2) counterclokwise (toward B) using a screwdriver. Then scurely tighten
the screws (1). (fig.15)
(fig.15)
www.garudan.cz