Anita Garudan GC-3317 Series, User'S Manual And Spare Parts Book

Page: 10 / 61

ANITA ©
GC-3317-443 MH
10
10. HOW TO INSTALL THE NEEDLE
Be sure to power-off the motor. The normal needle system is „DPx17“.
Turn the handwheel by hand and raise the needle bar to its top position. Loosen screw (1)
and insert the needle (2) into the hole until it will go no further. Insert the needle with its
receess (A) facing directly to the right-hand side. Securely tighten the screw in the needle.
(fig.5)
(fig.5)
11. HOW TO INSTALL THE BOBBIN
Put the bobbin (1) into the bobbin case (2). Pass the thread through the threading groove (3)
and the notch (4) of tension spring in the bobbin case. Fit the bobbin in the bobincase so
that the bobbin turns in the direction of the arrow when the bobbin thread is pulled. (fig.6)
(fig.6)
www.garudan.cz