Taking Care of your Pets
(Dog V3 - SlimDog V3)
Feeding your Dog
Dog (14500): I recommend the use of AW IC or IMR . The grey ultrafire do not fit.
SlimDog (10440): I recommend the use of ICR or AW IMR or Joyetech. I recommend to
NOT use the GTL as well as 600mAh battery (their stated values are completely false).
You can insert the battery either from the top or the bottom of the mod.,
Being careful attention to the direction of po up (side connector /spray). It is advisable
to do against the top to adjust the center pin to the right size
Setting the center post: Unscrew the top cap and then screw the atty on the connector.
From below, tighten the center post until it comes into contact with the atty. Then unscrew
the knurled nut so that it is long enough to make contact with the battery (this will probably
be done in several times)
Important: Do not force screwing on the thread of the mod when reassembling !
The Dogz and SlimDogz are lockable.
Please do not force when screwing the top and bottom caps to avoid damaging the threads.
As with any other mod, do not tighten too hard your atttys. It is useless, and this can damage
the mod and the atty (that can even cause a short circuit at long).
Cleaning your Dog
To maintain the beauty of your dogs, I recommend to use the "cape cod"wipe provided in the
black bag. It helps provide incredible mirror finish to your mods.
Instructions: - Gently rub your mod with the wipe until it leaves sort of black film (this is
normal)
