CNC Motion Setup/Testing Utility
P/N 70000634A
All rights reserved. Subject to change without notice.
23-December-05
7
Balancing Motion Control Axes
To balance the outputs properly, all connections between the CNC and
the servo amplifiers must be complete.
Perform all adjustments on one axis at a time. Make the adjustments in
the following order:
1. Select an axis
2. Balance the Motion Control Board outputs
3. Balance the Servo Amplifier outputs
4. Set Servo Amplifier gain
5. Repeat for all axes
Servo Amplifier Test Board
Each CNC that uses ANILAM AC motors and amplifiers, P/N 33001279,
includes a Servo Amplifier Test Board, P/N 33001399. During machine
operation, the board provides convenient access to critical signals for
alignment and troubleshooting. Refer to
Figure 4
.
NOTE:
The test board works only with amplifiers supplied by ANILAM.
ACTESTBOARD
Figure 4, ANILAM Servo Amplifier Test Board, P/N 33001399
Summary of Contents for 4200T CNC
Page 1: ...www anilam com ...