CNC Motion Setup/Testing Utility
P/N 70000634A
All rights reserved. Subject to change without notice.
23-December-05
4
Clearing a Prompt Field or Message (F1)
Press
ClrFld
(
F1
) to clear an erroneous entry. This soft key is available
during the Signal Gain and Tuning tests.
Selecting an Axis
NOTE:
Select an active axis before you select an MST command
(
F1
–
F10
). If you do not select an axis, the CNC displays an
Error
message that prompts you to select an axis.
Use the following keypad keys to select and activate the corresponding
axes:
X
Activates/Deactivates X-axis
Z
Activates/Deactivates Z-axis
S
or
S
Activates/Deactivates Spindle Axis
The CNC displays the active axis in the upper-left corner of the General
Status area of the MST Screen.
Entering a Password
When you enter the MST Utility and press
Balance
(
F6
),
SigGain
(
F7
), or
Tuning
(
F8
), the CNC prompts for the password. Type the appropriate
4200T CNC Setup Utility Manual
P/N 70000414, “Section 1, Password Restricted Parameters
The soft key activates. If you have entered the password successfully,
the CNC will not prompt for the password again, unless you exit and
re-enter the MST Utility.
X
Z
S
C
Summary of Contents for 4200T CNC
Page 1: ...www anilam com ...
