Angling Technics Limited
Procat MkIV
Note: When operating the boat all sliding trims
always be set centrally.
MUST
Handle
Propeller & Weed Guard
Drain
Holes
Blue LED
Low Battery
Warning LED
Hopper
Green LED
Red LED
On/Off
Push Button
Operation Instructions:
1. There is no external boat aerial as it is fitted internally.
2. The aerial on the transmitter has it’s optimum operating position when the aerial tip is vertical.
When the battery level falls to an unacceptable level an alarm will sound and the LED’s will flash.
3. The transmitter features sliding trims. All sliding trims are set in the middle of their movement.
4. Turn the Transmitter “ON”.
5. Connect the boat battery. Turn “ON” the boat using the “ON/OFF” button. Provided the LED joystick is in
the “up” position then all the navigational LEDs will be “on”.
6. Open the hopper door by moving the door catch forwards manually, or by moving the left-hand transmitter
joystick to the left or right. When opening the doors using the transmitter (not manually) then you MUST
wait approximately 15-20 seconds for the door catch to return to it’s natural position. Place you line and
hooked bait up through the open door and guide the line so that it trail from the “Line Guide” at the stern
of the boat, in the centre. Close the door, which will lock in place, load your bait into the hopper.
7. Place the boat into the water and using the right-hand joystick steer the boat to its destination. At the
desired position release the bait and your rig by moving the left-hand joystick left or right and this will
release the hopper door.
8. When the hopper is released the boat LED’s will go “off” until the joystick is back in the central position
and the hopper has opened. The hopper can operate independently of the other controls so you can have
the option to release the bait while the boat is moving. When the bait and/or line has been released guide
the boat back to you.
9. To get a minimum turning circle simply ensure that the boat is not moving and move the right-hand joystick
to the left or right (3 0’clock or 9 0’clock) leaving the joystick in the neutral position as far as forward and
reverse is concerned.
10. Moving the left-hand joystick (light control) fully backwards towards yourself will turn the navigational lights
(LED’s) to the “off” position. As you move the same joystick slowly forwards the navigational lights will come
“on” and gradually increase in brightness until they are fully “on”, when the joystick is fully forwards. When
the LED’s are “off” they will only come back “on” if the boat loses radio signal, and they will flash continually
until the radio signal is restored.
11. Remove the Procat from the water and gently close the hopper door. Switch “off” the boat by pressing the
button again.
12. Switch “off” the transmitter.
Thank you for purchasing this highly advanced fishing aid. Before you use it, please take a few
moments to read these instructions.
White LED
Power ON/Off
Directional Joystick
Aerial
Sliding Trims
Digital
Digital
Sliding Trims
PDM Button
(Non-Functional)
Lights & Door
Release
Joystick
Power LEDs
Neck Strap
Mounting
(Non Functional)
(Non Functional)
Ch2 D/R
Ch1 D/R
Handle
Battery Compartment