- 8 -
3220000_ut_GB
ENGLISH
GB
USE AND OPERATION
RECCOMENDATIONS FOR USE AND OPERATION
Important
The rate of accidents deriving from the use of
appliances depends on many factors which
cannot always be predicted and controlled.
Some accidents may be caused by unpredic-
table environmental factors, while others
are caused above all by users’ behaviour. As
well as being authorised and adequately in-
structed, if necessary, when they fi rst use the
appliance, users should also try out a few
“dummy runs” on procedures in order to get
to know the main controls and functions.
Use only as intended by the manufacturer
and do not tamper with any devices to obtain
operations other than those intended.
Before use, check that the safety devices are
properly installed and in good working or-
der. As well as undertaking to comply with
these requirements, users must apply all sa-
fety regulations and read the description of
the controls and the start-up instructions ca-
refully.
DESCRIPTION OF CONTROLS
The appliance is fi tted with the controls for use
of its main functions.
A)
Plate control knob
: turns the plates on and
off and sets their level.
B)
Mains light
: comes on to indicate that the
electricity supply is on.
C)
Failure indicator light (red):
this reports
an over-temperature in the components
compartment.
D)
Residual heat indicator light:
–
On
: this means that the glass-ceramic surfa-
ce is still hot.
–
Off
: this means that the glass-ceramic surface
is cool.
6
5
2
4
3
1
A
6
5
2
4
3
1
A
B
B
C
A
C
D
Rear plate
marker
Off marker
Front plate marker
Power marker
On/off external heating
element marker
