6. TROUBLE SHOOTING
(a) Pump does not operate when solar panel is in full sunlight.
Check:
All Wiring and connections from pump to the solar panel.
Check:
If Impeller is blocked with debris, clean the pump as
described in previous section.
(b) Pump does operate but water flow is very weak.
Check:
Low water level causing air in tubing. Fill with water and
restart system.
(c) Operating time is shorter than preset time.
Not enough electricity stored in the batteries. Charge properly.
7. TECHNICAL DATA
Item Number
P006B
Solar panel
1.2W – 7V
Pump Operation Voltage
DC 4.5V – 6.5V
Maximum Water lift
0.5 meter
Maximum Flow Rate
150 L/H
LED light Operation Voltage
DC 6V
WARRANTY
Pump is covered by a one year limited warranty
Solar Panel is covered by a one year limited warranty.
Batteries are covered for 90 days.
For more information on our solar items, please visit our web site:
www.angelodecor.com
To contact us regarding this unit, your options include:
Email:
Phone: 780 – 453 6646
Fax: 780 – 453 6620
SOLAR / HYBRID FOUNTAIN PUMP USERS MANUAL
Please see our website
angelodecor.com
for video version of assembly and use
1.
BEFORE YOU BEGIN – ASSEMBLY
¾
Unpack all components
carefully.
¾
Install the 4 batteries (supplied), in proper orientation (+/-), in the
housing at rear of solar panel using the small screwdriver (supplied)
¾
TIGHTEN BATTERY COVER SECURELY FOR PROPER SEAL
¾
Fully charge the unit
direct sunlight (minimum 8 hours
¾
2.
PREPARATION FOR USE
¾
Connect the pump cable to the correct socket of the housing
on the rear side of the solar panel.
¾
Connect the tubing to the pump and
input on the solar panel as shown.
¾
Adjust flow control on pump to desired strength.
¾
Install assembled unit into the fountain,
ensuring the pump sits at bottom of water reservoir.
¾
Fill fountain water reservoir area to capacity,
ensuring the pump is completely submersed in water.
