Valia Solar Fountain
AD93116
We hope you will find these instructions helpful in setting up your product.
If you have any issues with this item, DO NOT return the unit to place of purchase.
Please visit our web site
www.angelodecor.com
for assistance and warranty information.
The included LED light
comes pre-installed.
Pass the light and
pump cords down the
cord pipe in the bowl.
Place the cord pipe
cover over the pipe
as shown.
Arrange all pieces in
your workspace.
Carefully lift and
lower the bowl on to
the pedestal. Align
Connect the tubing
from the top to the
pump.
Gently lower the top
in place. Align the
grooves and twist to
l
k i
l
Pass the power cord and
light cord down the
pedestal and out the
b
Align the cords from the
pump and light with the
groove at the base of the
d
t l
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
Product must be properly stored for winter.
The included LED light
comes pre-installed.
Pass the light and
pump cords down the
cord pipe in the bowl.
Place the cord pipe
cover over the pipe
as shown.
Operating Instructions
For complete operating instructions, please see the included manual.
1. Install the included batteries.
2. Attach the included stake to the panel.
3. Fully charge the unit with the included charging cable or a minimum of 6
hours of direct sunlight.
4. Connect the pump and light to the corresponding socket s on the panel.
5. Place the panel in a location where it will obtain consistent direct sunlight.
6. Fill the fountain with clean water.
7. Turn the device on by pressing the power button.
8. Toggle the device to the desired method of operation: Direct solar or
Battery Power.
Direct Solar Power is the default method of operation. Battery Powered
operation will work for a period of up to 4 hours with a full charge.
The final assembly should look like
this
Arrange all pieces in
your workspace.
Carefully lift and
lower the bowl on to
the pedestal. Align
the grooves, then
twist and lock the
bowl to the pedestal.
Connect the tubing
from the top to the
pump.
Gently lower the top
in place. Align the
grooves and twist to
lock in place.
Pass the power cord and
light cord down the
pedestal and out the
base.
Align the cords from the
pump and light with the
groove at the base of the
pedestal.
