AIRPRO [L]
20
5.10
Blades Assembly
To assemble the blades, it is necessary to screw the plastic end caps, and introduce and fix them to the motor
guides. Use the M6 bolts to fix the plastic end caps before lifting the blade to the motor.
10. Insert the end-cap into the blade
and tighten with the 7 bolt kits as
picture shown.
Please. Process this step on the
ground.
Recommended Tightening Torque:
5Nm.
Use End-Caps Bolt Kit (7 x M6*45)
.
Once the end caps are screwed, remove the plastic protection film and proceed to lift the blade to the motor. Take
care to avoid any damage on the blades paint. The fan blades must be installed in a specific sense, with the
concave side in the bottom.
11-1. Insert the blade into the blade
guide and tighten it. Recommended
tightening torque: 12Nm
11-2. Place retainer over the blade
and spans to the other blade.
Use
Blades Bolt Kit (21 x M8*45).
CAUTION!
Make sure the blades are installed in the correct sense.
Failure to do so may result in incorrect installation.
Tighten the outside bolts first and then the inside bolts with the blades’ retainer.
Failure to do so may
result in incorrect installation.
Check that there are no objects that can avoid the blades rotation.
Failure to do so may result in equipment
damage.
Retainer
