OnTheGo LiTE User Guide
Getting to Know Your OnTheGo LiTE:
1)
Lanyard Loop
2)
LED
3)
Speaker
4)
HELP Button (Emergency Button)
5)
Microphone
6)
Charging Cable (Not Shown)
7)
Lanyard (Not Shown)
Charging Your Device:
Whenever you put the plugged-in charging cable near the charging port on the back of the device, it should latch into
place and the device will automatically power on. The LED will turn solid red and the device will announce, “Your
device is now charging.” Note: If you have allowed the battery to completely drain, it may take a few minutes for the
device to power on.
When the device has adequate battery charge and is also connected to the cellular network, it will announce, “Your
device is now ready.” This indicates that your device is ready to make an emergency call. However, you should leave
your device on the charging cable until the LED is green, indicating that your device has completed charging.
A complete charge will take approximately 2-3 hours. When fully charged your device should work for up to three
days before needing to be recharged.
LED
Announcement
What this means
What you should do
Solid Red
“Your device is now
charging.”
Device is connected to the
charger
Leave on charger until
battery is charged and the
LED is green
Blinking Red
“Your device battery is
low. For your protection,
please place your device
on the charger now.”
Your battery is critically
low
Place device on charger as
soon as possible
Blinking Green
Your device has adequate
charge and is looking for
cellular connection
Wait. If this continues
move to another location
with better cell coverage
Solid Green
“Your device is now
ready.”
Your device is ready to
make a call
Press the button if you
wish to make a call
Placing an Emergency Call:
HELP Button Action
Announcement
What this means
What you should do
To place a call, press and
hold for 1 second or
more
Device will BEEP and
announce “Placing an
emergency call now. To
cancel the call please press
and hold the HELP button
for two seconds now.”
Device will make a call
Release the button
To cancel a call, press
and hold for 2 seconds
after the “Dialing the
emergency response
center….”
announcement
“Your call has been
cancelled.”
The call has been cancelled Release the button
#1
#2
#3
#4
#5
