DN:KD-752-SMSY01 V1.0 Operation Guide
10/19
Stay quiet, calm for 5 minutes before blood pressure measurement.
Please keep the cuff clean. Clean the cuff by wet soft cloth and mild detergent
if the cuff becomes dirty. Do not remove the cuff from the monitor.Clean the
cuff after the usage of every 200 times is recommended.
Do not place the cuff around your wrist if the wrist has any inflammation, acute
diseases, infections skin wounds.
6. BODY POSTURE DURING MEASUREMENT
Sitting Comfortably Measurement
a.
Be seated with your feet flat on the floor, and don
’t cross your legs.
b.
Place palm upside in front of you on a flat surface such as a desk or
table.
c.
The middle of the cuff should be at the level of the right atrium of
the heart.
7. TAKING YOUR BLOOD PRESSURE READING
（
1
）
SELECT STANDARD OR MULTIPLE MODE
This device enables you to select either standard or multiple
mode. The standard mode is standard single measurement, and
the multiple mode is automatic triple measurement. Since blood pressure constantly
fluctuates, the blood pressure reading from multiple measurements is much more reliable
than that from only one measurement.
Slide the standard / multiple switch on the right side of the monitor toward to
”1” to select
standard mode, and toward to
“MULT” to select multiple mode before measuring blood
pressure.
（
2
）
STANDARD MODE
a.
After applying the cuff and your body is in a comfortable position, place the standard /
multiple switch on the
“1” side.
b.
Press the
“START” button. All display characters are shown for self-test. You can
check the LCD display according to the picture. Please contact the service center if
segment is missing.
See picture 7-1
.
c.
Then the current memory bank is blink.
See picture 7-2.
Press
“MEM” button to
change over to other bank. Confirm your selection by pressing
“START” button. The
current bank can also be confirmed automatically after 5 seconds with no operation.
d.
Then the monitor starts to seek zero pressure.
See picture 7-3
.
e.
Then the cuff will be slowly inflated. The blood pressure and pulse will be measured
during inflation. Inflation will stop as soon as the blood pressure and pulse rate have
been calculated and displayed on the LCD. The irregular heartbeat symbol (if any)
and blood pressure classification indicator will blink on the LCD.
See picture 7-4
. The
result will automatically be stored in the Memory bank of the monitor.
