Anderson WRAPTOR, Operator'S Manual

Page: 37 / 70

35
11 Reassembling the Hoop
Outer Hoop
Place the 4 sections flat on the ground.
Place a 3/8” wide metal spacer on the ground in the center of each section so that the sections
are parallel to the ground.
Each end piece is numbered from 1 to 4. Each end piece must be placed with its corresponding
number.
Next bolt the sections with 3/8x1 carriage bolts.
Only tighten the bolts when they are all in place.
Figure 11.1 Outer hoop
Inner Hoop
Be careful not to tighten the bolts before the final step.
Bolt part (A) of the hoop onto the bale wrapper.
Bolt the lower two quarters of the hoop with the fastenings (B).
Bolt the fastenings to the machine (C).
Bolt the upper quarter of the hoop (D) onto part (B).
Tighten the bolts.
Figure 11.2 Inner hoop
Remove 5 of the rollers that are attached to the outer hoop. Keep the next 3 rollers in place.
Place the outer hoop around the inner hoop.
Reinstall the 5 rollers.
B
B
C
D
C
A