Anderson WRAPTOR, Operator'S Manual

Page: 28 / 70

26
Figure 8.2 Remote operation module
Operation
Turn the module’s green button to ON (Figure 8.2). This button will blink while the remote
control is starting the engine (Figure 8.1) and then will remain on. Press the right and left
arrows to turn the machine. The hydraulic stop button will work if needed. If it is not used, the
module will automatically shut off after a certain period of time in order to preserve the battery.
A 12V recharging wire with car cigarette lighter attachment is included with the remote control.
Programming
Your remote control was associated with your TAC-02C module in the factory. If this did not
happen, or if you have a new remote control, perform the following steps:
1 – Turn the green button to ON. The button will light up.
2 – Immediately turn the green button to PRG. Let it return to OFF by itself.
3 – Press one of the remote control’s buttons (be aware that the pusher button is inoperative).
The green button will blink and then turn off. Your remote control is now programmed.
Note: For safety, be careful not to immediately move the button to ON after PRG because the
held-down button could immediately start the machine.