Anderson TSR-3450, Operator'S Manual

Page: 43 / 70

Anderson Group Self loading trailer TSR-3450
– Operator’s Manual 41
7 Troubleshooting
The following table describes the most common problems that you may come across with the
wrapper. It also gives solutions to resolve them. If your problem does not appear in this
table, or if you do not manage to resolve it by yourself, communicate with the service
department of your dealer or with the Anderson Service department (See section How to Reach
Us at the beginning of the manual for our contact information).
Problem Possible causes Solution
The loading arm
does not move.
The pin retainer is blocking the
cylinder.
Remove the pin retainer and try again.
The hydraulic hoses are not attached
correctly to the tractor.
Check the hydraulic hose attachments.
An obstacle is blocking the
movement of the loading arm.
Make sure that nothing is in the way of
the loading arm.
Electrical problem, connectors or
sensors
Make sure that electrical wires and
connectors are in good condition.
Make sure that limit switches on the
loading arm are in good condition
The pusher does
not move.
The loading arm is too high. Lower the loading arm.
The hydraulic hoses are not attached
correctly to the tractor.
Check the hydraulic hose attachments.
The security device of the loading
arm is not working.
Check the cleanliness of the pivot point of
the loading arm.
Electrical problem, connectors or
sensors
Make sure that electrical wires and
connectors are in good condition.
Make sure that limit switches on the
loading arm are in good condition
The unloading
platform does not
move.
The loading arm is too high. Lower the loading arm.
The hydraulic hoses are not attached
correctly to the tractor.
Check the hydraulic hose attachments.
The security device of the loading
arm is not working.
Check the cleanliness of the pivot point of
the loading arm.