Anderson TSR-3450, Operator'S Manual

Page: 27 / 70

Anderson Group Self loading trailer TSR-3450
– Operator’s Manual 25
4.5 Loading arm position
The loading arm can be adjusted to pick up bales from .9m to 1.2m (3 to 4ft) or for double
stack. The following diagram shows the adjustment of the arm according to the height of the
bales you are working with.
Figure 4.5 Loading arm position
The following steps will allow you to change the position of the loading arm so you can load
bales of 1.2m (4ft) high or for double stack.
1- Drop the loading arm to the ground with the joystick.
2- Support the loading arm (the pivoting part) with an appropriate jack / support.
3- Remove the pin (A) from the pivot and also (B) from the cylinder.
4- Raise the loading arm to align the holes with the upper position of the pivot.
5- Replace the pin and lock it in place.
6- Raise the end of the pinchers to align the base of the cylinder with its pivot support.
7- Replace the pin (B) by putting it in the upper hole of the pivot (E).
8- Move the selection valve (D) to the appropriate hole (F).