Anderson SMARTMIX A1230FD, Operator'S Manual

Page: 97 / 129

Anderson Group Mixer – Operator's Manual 95
Figure 48 — Location of the Shear Bolts on the A950 and A1230 SMARTMIX
After emptying the machine, check the indexation
of the mixing augers (their positions in relation to
each other). The front auger scraper (see Figure
49-D) and middle auger scraper (see Figure 49-E)
must be offset from each other by 90°. The middle
auger scraper (see Figure 49 - E) and rear auger
scraper (see Figure 49-F) must also be offset from
each other by 90°.
To synchronize the mixing augers:
1. Disconnect the drive shaft from the middle auger.
2. Using the tractor PTO, rotate the front auger into Position D and the middle auger into Position
E.
3. Once the first two augers are synchronized, reconnect the drive shaft to the middle auger.
4. Disconnect the drive shaft from the rear auger.
5. Using the tractor PTO, rotate the rear auger into Position F.
6. Once the augers are synchronized, reconnect the drive shaft to the rear auger.