Anderson SMARTMIX A1230FD, Operator'S Manual

Page: 43 / 129

Anderson Group Mixer – Operator's Manual 41
2.4 Safety tips for maintenance and repairs
2.4.1 General
Moving parts involve pinching and cutting hazards.
l
Maintenance and repairs must be performed by qualified individuals.
l
Always keep the equipment and its accessories in perfect condition.
l
Keep the oil tanks clean.
l
Follow the maintenance intervals.
l
Before beginning work:
l
Turn off the engine and remove the key from the ignition;
l
Put the gearshift in neutral and apply the handbrake;
l
Disengage the PTO and uncouple the drive shaft from the PTO;
l
Disconnect the hydraulic supply hoses;
l
Wait for all moving parts to come to a complete stop;
l
Place the support and stabilizing devices (wedges, stand, etc.);
l
Let the gearboxes and hydraulic components cool, as well as any other parts of the
machine that may be hot.
2.4.2 Welding
When welding, place the grounding device as close
to the welding area as possible.
The load cells should never be between the weld
and grounding device.
l
For welding operations on the equipment or tractor, disconnect the battery or electrical power
supply and protect the lines (especially rubber hoses) to prevent them from being damaged
by sparks, which could cause a loss of oil, hydraulic fluid, etc.
l
Move any combustible materials (hay, organic matter, gasoline, etc.) away from the area
before welding.
l
Eliminate any risk of fire.
2.4.3 Electrical
l
Before starting work on the electrical system, disconnect the battery or electrical power
supply.