Anderson SMARTMIX A1230FD, Operator'S Manual

Page: 100 / 129

98 Operator's Manual – Mixer Anderson Group
Avoid entering the mixing chamber to clean it, as
you could fall and cut yourself on the knives. Use
appropriate cleaning tools, such as a pitchfork,
broom or pressure washer.
If you must enter the mixing chamber, wear non-
slip shoes, gloves, coveralls, etc. and cover the
knife edges.
If entering the mixing chamber through a hydraulic
hatch, close the safety valve to prevent the hatch
from closing.
7.1 Maintenance schedule
The following table summarizes the maintenance tasks and their required intervals, which will be
covered in the following sections.
Table 14 — Maintenance Schedule
Task Daily
Before
the
first
use
After the first (hours) Every (hours)
Annually
(2000
hours)
See Section
10 50 100 50 100 200
Grease the uni-
versal joints (drive
shaft)
X X "Greasing"
on page 102
Grease the drive
shaft
sliding
sleeves
X "Greasing"
on page 102
Grease the gear-
box on the upper
part of the plan-
etaries X "Greasing"
on page 102
Grease the bear-
ings X "Greasing"
on page 102
Grease the cylinder
joints X "Greasing"
on page 102
Grease the walking
beam tandems X "Greasing"
on page 102