29
The LS_BA sensor should be setup in an OFF position while not in use. The sensor needs to
activate when the small arm is being pushed and then turn off again.
To set this sensor up properly you must first adjust it high enough so that its light does not
turn on and slowly press on the small arm so that the sensor gets activated by the small
arms bottom corner.
Adjust it so that the sensor activates fairly early. (See picture 2 for activated sensor.)
Hard to see but this is
activated (hair trigger
gives the arm more tme
to lift before drag is
noticed on the bale)
Tip: 3kmh pick up speed
very important
PROCEDURE REF# A-RBM-013
Adjustment of the clamp’s bale sensor (LS_BA sensor)
Summary of Contents for RBMPRO
