21
1. Plug in your 12V power cable (included with the RBMPRO) Directly to the
terminal or to the COBO plug inside your tractor’s cabin. This cable powers up the
electro-
hydraulic control's and the RBMPRO’s computer screen.
NOTE : If no terminal or COBO plug is available in the tractor, plug in the power
cable directly to the tractor’s battery using this adaptor.
2. Plug in the other side of the 12V power cable to the connector labeled as “B” on
the trailer’s computer. (see picture below)
NOTE : The “A” cable must be plugged onto the trailer’s computer
3. Plug in the electrical plug for the tail lights on the tractor’s 7 pin plug.
4. Verify that the connection between the tractor’s flashers and the trailer are
working together.
PROCEDURE REF# A-RBM-004
Connecting to the tractor (electric)
Summary of Contents for RBMPRO
